Standard Specification for Polypropylene and Extrusion Materials. ASTM D To request a quote for this test or others. Click Here. Buy ASTM D CLASSIFICATION SYSTEM AND BASIS FOR SPECIFICATION FOR POLYPROPYLENE INJECTION AND. Designation: D – Standard Specification for. Polypropylene Injection and Extrusion Materials1 This standard is issued under the fixed designation D.
|Published (Last):||9 June 2005|
|PDF File Size:||14.9 Mb|
|ePub File Size:||5.58 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view astmm versions of standard. This specification covers polypropylene materials, suitable for injection molding and extrusion, that include unreinforced polypropylene with natural color only, unfilled and unreinforced polypropylene, calcium carbonate filled polypropylene, glass reinforced polypropylene, polypropylene copolymers, and talc filled polypropylene.
Polymers consist of homopolymer, copolymers, and elastomer compounded with or without the addition of impact modifiers ethylene-propylene rubber, polyisobutylene rubber, and butyl rubbercolorants, stabilizers, lubricants, or reinforcements. Tests shall be conducted on each of the specimens 4d101 determine the required physical and mechanical properties of the materials.
The specimens for the various materials shall conform to the following requirements: This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.
Polymers consist of homopolymer, copolymers, and elastomer compounded with or without the addition of impact modifiers, for example, ethylene-propylene rubber, polyisobutylene rubber, and butyl rubber, colorants, stabilizers, lubricants, or reinforcements.
The proportions of recycled, reconstituted, and reground material used, as well as the nature and the amount of any contaminant, cannot be practically covered in this classification system. It is the responsibility of the supplier and the buyer of recycled, reconstituted, and reground materials to ensure compliance.
Materials at AB Plastics, Inc.
No other units of measurement are included in this standard. The properties included in this classification system are those required to identify the compositions covered. If other requirements are necessary to identify particular characteristics important to specific applications, these shall be designated by using the suffixes given in Section 1. This standard does not purport to address all of asmt safety concerns, if any, associated with its use.
Plastic Testing Leader-Elastomers-Composites-Polymer testing PTLI
It is the responsibility of the user of asttm standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. D Test Method for Plastics: Historical Version s – view previous versions of standard Translated Version s: Link to Active This link will always route to the current Active version of the standard.